Every so often I get a 5 or 6 blink status on my 2006 Harman Accentra. I have asked about this before but don't pursue it as it is the type of problem that causes "minor" inconvienience. Lately, the stove has been running good. The igniter area is clean...I can get the blinks when i run on stove or temp. mode sometimes. I wonder if I was using older pellets, or if the stove is getting "gummy" where the pellets feed. Or at times I wonder if a sensor could actually act intermittant....like the room temp bulb or the ESP in the exhaust. Can aging gaskets with door or burn pot cause draft leaking which can cause poor combustion?
Dirty stove or Bad sensor?
- Thread starter Val
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
