Hi all! New member here!
So I have an Enviro M55 stove that's been having some recent issues. The other day when I went to start it, it ran great; then the fire began to get very small for no reason. It was on setting 3, and we're burning corn in it. Normally with corn, setting 1 is barely enough to keep it going, so we've always run it on 2 or higher. Now, no matter the setting(1-5), it acts like it's on less than 1. Auger run intervals are few and far between, even on setting 5. I pulled it out on the service rails, cleaned it up, and looked for any unplugged wires; didn't see anything unusual. I also made sure it's set for "multi-fuel", and no difference. Maybe I'm missing something simple, but either way, I want my "hot spot" going again. Thanks in advance!!
Ezra
So I have an Enviro M55 stove that's been having some recent issues. The other day when I went to start it, it ran great; then the fire began to get very small for no reason. It was on setting 3, and we're burning corn in it. Normally with corn, setting 1 is barely enough to keep it going, so we've always run it on 2 or higher. Now, no matter the setting(1-5), it acts like it's on less than 1. Auger run intervals are few and far between, even on setting 5. I pulled it out on the service rails, cleaned it up, and looked for any unplugged wires; didn't see anything unusual. I also made sure it's set for "multi-fuel", and no difference. Maybe I'm missing something simple, but either way, I want my "hot spot" going again. Thanks in advance!!
Ezra
