i have top exit on a v.c. resolute acclaim.i have a nice heavy gauge welded 6 inch single wall pipe.my concern is i dont think it is tight enough at the collar where it is screwed in.i can look down and see light from my flame.is alright to have some gaps? i was thinking of sealing it with some stove cement.
flue collar
- Thread starter willty
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
hey caz,heres some pics there is no crimped end on this pipe going into the flue .got it all assembled yesterday.it used be rear exhaust at my dads so the local stove dealer supplied me with these three peices.i know as soon as i close the damper:im afraid im gonna smoke out the place.
Attachments
If i understand you right, you,ve sealed off the back flue collar and cut a hole on the top of the stove and fastened a
fabricated flue collar on top. I don't know if this set-up is safe or if it will even draft properly. I suggest you contact Vermont Castings.
http://www.vermontcastings.com/content/products/productdetails.cfm?id=292
fabricated flue collar on top. I don't know if this set-up is safe or if it will even draft properly. I suggest you contact Vermont Castings.
http://www.vermontcastings.com/content/products/productdetails.cfm?id=292
hey caz,the resolute has areversable flue top or back.its just that it was not tight as i would like.i can see another [post after mione pointining me in the right direction either trim the pipe or buy an adapter for a better fit .
might want to chk this .....
https://www.hearth.com/econtent/index.php/forums/viewthread/15410/
i mentioned in there,
i used foil tape at my collar joint.
wrap it around, smooth it in.
can get it anywhere.
https://www.hearth.com/econtent/index.php/forums/viewthread/15410/
i mentioned in there,
i used foil tape at my collar joint.
wrap it around, smooth it in.
can get it anywhere.
you'd think, its just regular foil tape.
the tape i used was the foil tape that came with the flue liner insulation so i used it.
its been 4 months and its still on, knock on wood. still glued to the collar and pipe. wrapped it 3 times so its glues to itself also.
i'd rather replace the tape every year or so rather then pull my collar/pipe apart... it was hard enough lining everyting up and getting it in.
the tape i used was the foil tape that came with the flue liner insulation so i used it.
its been 4 months and its still on, knock on wood. still glued to the collar and pipe. wrapped it 3 times so its glues to itself also.
i'd rather replace the tape every year or so rather then pull my collar/pipe apart... it was hard enough lining everyting up and getting it in.
pgmr said:
One would think, but I still have the stickers on my double wall stovepipe stuck on my flue collar adapter.
Either it is some sort of heat resistant glue or my stove doesn't burn all that hot. :bug:
J.P.
- Status
Similar threads
