Had to replace PB-105 control board

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
Former Farmer

Former Farmer

Minister of Fire
Apr 12, 2008
709
NE Wisconsin
Ended up having to replace the control board on my PB-105. Darn thing was blowing fuses left and right.

Finally narrowed it down to the ignitor relay never opening. Ignitor was on all of the time and after 45 minutes to an hour, it would blow the fuse. ESP was good because the unit recognized when the fire started. I switched the control board to manual and the ignitor still had power to it. Time for a new board.
 
Status
Not open for further replies.

Similar threads

R
Harman P68 Ignition Problems
Replies
15
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
NS P-68
NS P-68
J
Harman Absolute 63 Blown Fuse Still After Some troubleshooting
Replies
8
Views
911
The Pellet Mill - Pellet and Multifuel Stoves
Iburnslow
Iburnslow
G
Control board failure on Pleasant Hearth pellet stove?
Replies
3
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
physicswhiz
P
B
accentra board problems
Replies
0
Views
513
The Pellet Mill - Pellet and Multifuel Stoves
bobbyj
B
W
Heatilator PS50 auger not powering on
Replies
1
Views
744
The Pellet Mill - Pellet and Multifuel Stoves
Wb99
W
Top Bottom
Back