Harman 52i Room Sense Issue after probe replacement - must ice probe for stove to run

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
B

Bob NH

Member
Nov 17, 2019
1
NH
Great forum! Used brain trust to get me to replace room sense probe on our Harman Elantra 52i. After doing so 4 blinks went away, but stove would shut off after 2 sec in room mode. Tried suggested test of putting room probe in ice. Voila! Fires up. Runs fine, but soon after removing probe from ice pellet feed stops.

Suggestions on next step(s)?

thanks!
 
You must log in or register to reply here.

Similar threads

BGStG1aholic
Harman XXV hard starting
Replies
4
Views
397
The Pellet Mill - Pellet and Multifuel Stoves
NHMAN1
NHMAN1
R
Harman Accentra 2 blink
Replies
6
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Washed-Up
Washed-Up
A
Harman P68 Stove Temp Issue
Replies
8
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
Alwgend
A
J
Harman P35i Issues
Replies
10
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
jasonwp
J
BGStG1aholic
Harman XXV ignitor hardly works and starting via firestarter gel is a bearcat
Replies
9
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
MarkF48
MarkF48
Top Bottom