Harman PF100 Flame

[bfraymond]

I have used the stove this year and all systems were fine. I cleaned the exhaust flue, the burn pot and the entire combustion area. After this cleaning, the pellets are not burning completely and the flame is not going straight up not across at roughly a 45degree angle as it was. I have noticed the pellets falling out the sides before the burn pot. Any suggestions? New flame guide?

Thanks
Brent

 

[Whitenuckler]

I have used the stove this year and all systems were fine. I cleaned the exhaust flue, the burn pot and the entire combustion area. After this cleaning, the pellets are not burning completely and the flame is not going straight up not across at roughly a 45degree angle as it was. I have noticed the pellets falling out the sides before the burn pot. Any suggestions? New flame guide?

Thanks
Brent

I'd check your combustion blower and fresh air supply. I have a P43, so I'm not sure about your stove. Turn the feed rate down until you figure it out.