Hello I am new to this board. I have a Harman PP38+ pellet stove. My problem is my stove doesn't produce enough heat to cause the blower to turn on causing my basement to stay cold. It stay's lit (it's just a small flame no matter if I turn the feed knob all the way up). The only way I get the blower to work is turn the stove off and then back on the blower blows warm air and the auger feeds the pot to cause a large flame (but after about 45 seconds the blower turns off and the flame get smaller). Someone told me to buy a new circuit board but also was told it might be the knob for the feeder? Any suggestions? Thanks
Harman Stove PP38+
- Thread starter spesoftball
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
