Harman xxv 13 years old

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here

terryg

Member
Nov 5, 2017
3
Massachusetts
I just replaced control board. Followed part instructions for installation and dip switch settings. Turn stove on, the following happens;
Both blowers on
Igniter lite goes on for 2-3 seconds, then shuts off.
Feed motor light, does the same. as igniter.
Getting 3 blinks on error light. Manual says ESP malfunction, unplug stove for a few seconds then plug back in. No help.
All of these items were working when I shut down last spring.
Could an improper dip switch setting #5), off instead of on, cause all of these issues?
Any help appreciated. Contacted seller, have not heard back yet.
 
From what I remember #5 is on for a red esp and off for the black one