The last few times I have cleaned my PF 100 the ash pan is full of hot coals and I am having to wait for them to cool down to clean. I am using the same pellets as I always have. It doesn't seem to be burning the pellets effectively. I need some help with what I should be looking at.
Hot Coals in Ash Pan - Harman PF 100
- Thread starter Jesszh
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Turn your feed rate down. If it's at 5 turn it to 4.5 and watch it. Ideally you want the pellets to stop burning about 1" from the end of the burn pot.
You may have to adjust it a couple of times until you find the sweet spot.
You may have to adjust it a couple of times until you find the sweet spot.
Mine is auto by thermostat. I have both down and I am still finding the same issue
Page 22 and upper right hand corner of figure 42 is what I'm talking about. Turn that setting down by 1/2 step and see if unburned pellets are still falling into the ash pan. If they are turn it down 1/2 step again. If it's set on 6 turn it down to 5 and 1/2
http://downloads.hearthnhome.com/installManuals/PF100.pdf
http://downloads.hearthnhome.com/installManuals/PF100.pdf
