Problem with 1992 Austroflamm Integra pellet stove fan
bypassing the low limit switch the convection fan still does not run
I replaced the convection fan, tested working with a lamp cord.
Combustion fan is on and continuously running
I replaced the low limit snap disk and gasket
Problem is convection fan not turning on at all unless direct wired with the lamp cord.
Jumping the low snap disk doesn’t work either. I can’t figure out why not.
Stove will burn fine through warm up but then shuts down.
I need help figuring out why the convection fan is not turning on. Control Board?
bypassing the low limit switch the convection fan still does not run
I replaced the convection fan, tested working with a lamp cord.
Combustion fan is on and continuously running
I replaced the low limit snap disk and gasket
Problem is convection fan not turning on at all unless direct wired with the lamp cord.
Jumping the low snap disk doesn’t work either. I can’t figure out why not.
Stove will burn fine through warm up but then shuts down.
I need help figuring out why the convection fan is not turning on. Control Board?
