New pellet stove owner needs help!

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

RussMT

New Member
Jan 25, 2013
1
Stevensville, MT
Hello! I have recently purchased a new home. The home came with a pellet stove. My wife and I have never had a pellet stove and are still a bit confused by it. We are used to the traditional heating - wood stoves and propane furnaces. We do also have a propane furnace and baseboard heating in the house - but really could use this pellet stove to get the job done on subzero nights to efficiently heat the house throughout! We live in the Bitterroot Valley in Western Montana. We love the house and were disappointed to see this "wood stove" that we had to "plug in".
We have been using the pellet stove, but it has been a pain. Auger jams, burner section piling up with rock hard soot, difficulty starting, massive flare ups that set off the smoke detectors in the house. We fully plan on installing a traditional wood stove when we have the finances to do so, not only due to our difficulty with the pellet stove, but mostly due to the fact that it needs AC power to run. If the power goes out and it is 10 below - we are screwed with the pellet stove. Every other heat source ALSO needs AC power. ALSO pellets are a rip off. It is like $170 - $210 dollars a ton. I can get a permit here for $13 dollars and harvest 7 cords of wood up in the hills to heat my home for nearly two years with a traditional wood stove that requires no AC power! Im only in my late 30s and hope to split wood till I die, BUT could only see the advantages of a pellet stove for possibly the elderly or disabled. But alas, I am stuck with it now.
The seller failed to leave me any documentation on the pellet stove. Based upon the labels on the unit I have concurred that it is partially constructed in Alberta by Canadian Comfort Industries (CCI) and for the electronics by Danson in Louisiana. I have found no model number, nor any other helpful info to use in troubleshooting or just basic operation. To be more specific, on the RH side of the pellet stove, there is a user control panel to operate the device, labeled "Accutron II". There is an 1-877 number on a label that I called. I got a sweet gall in the S.E. USA that had no idea about pellet stoves. What the Monkey?
I do now understand that there are a myriad of pellet selections. I have been pulling my hair out by using the ton of pellets left by the seller. They are Rocky Canyon red fir pellets. Made in Graingeville, ID. NOT impressed. Very pricey at almost $200/ton. I tried a few bags of Blazer that I bought at Home Depot for much less. That was a noticeable improvement.
I also understand that people in other parts parts of the country may not be able to head up into the hills with a chainsaw and pickup truck/trailer and slay trees for nothing. I apologize for maybe not understanding the reasons that other folks may benefit from a pellet stove. I just see little logic in having one where I live. I DO have a small guest cottage on the property that I could put it in. Maybe stick it in there and keep the baseboard heat going to prevent freezing...and let family/guests spark up the pellet stove as they wish. I also have a big 30x40 shop - but feel that it is underkill for heating that building with 14 foot ceilings.
I AM being very pessimistic AND hyper critical of my pellet stove. I am really a laid back guy - but lose my head when a heating source for my family is not functioning properly and have no respect for it when its a wood stove that needs power to operate!
Any advice from "can it you fool!" to "let me help" will be greatly appreciated! Maybe even "I'll buy it from ya!" would be cool. I love to barter ;). I'll trade it for a .44 mag or a .45-70 lever action. Maybe some powder or bullets. Horse? Sheep? Hot tub. LOL please help me with my computer controlled wood stove! Beleive it or not I have a degree in engineering and licenses in Aircraft Maintenance. I deal with logic and specifics everyday and dont want to go home and troubleshoot a friggin fireplace!!!! I want to come home from work, love on my wife and kids, and darnit.....go outside and split wood if I need to! Id rather split wood in ten below than curse a pellet stove while I shiver.
Any advice for this young/stubborn homeowner would be greatly appreciated and I will not combat with sarcasm if I can't help it! ;)
 
Looks like it may be a Pelpro stove: www.pelletstovefires.com/pelpro-pellet-stove.html

Does it look like these?
www.dansons.com/pdfs/manuals/pelletstoveoperations102506.pdf

EDIT: not sure why the 2nd one doesn't show as a link. Try pasting it into the address bar of your browser.
 
Do you know when the last time the stove was thoroughly vacuum cleaned, including vent piping? That and the pellet choice will diminish performance and frustrate the heck out of anyone.
 
Woah! $170 - $210.00 / ton! No need to be complaining there ;)

Well Russ, that was quite a post and plenty of members here can relate to your situation. I heated my entire house with a wood stove for 8 or so years and do it now entirely by pellet - it is a different game and your lifestyle are factors in the transition. You came to the right place for info though, and my first advice here is to relax and take in all the info and advice before you write off the pellet stove. It sounded like you are off to a terrible start. Right of the bat, the majority of your problems can all be attributed to inferior / bad quality pellets and/or a dirty stove. Any pellet that creates 'clinkers' (that rock hard soot you mentioned in the burnpot) is a no good pellet for your stove, get rid of them right away and start burning the good stuff.

Once you have quality fuel and get the stove dialed in, it can be smooth sailing. I'm not sure if you mentioned the model of your stove, but you may want to put it in your signature to help w/troubleshooting.
 
Wow...I think you have it figured out my friend, Yank out the pellet stove and buy yourself a wood burner!! Finances are tight for most of us, but the hate you have for the plug is obvious...So scrape up some dough (+13 dollars), go cut your wood and in a couple of years you will have heat!
 
Wow...I think you have it figured out my friend, Yank out the pellet stove and buy yourself a wood burner!! Finances are tight for most of us, but the hate you have for the plug is obvious...So scrape up some dough (+13 dollars), go cut your wood and in a couple of years you will have heat!

and a sore back...
 
What do you do to run your lights when power goes out or do you have a wood lamp of some sort. LOL Most of the members were at one time wood burners.

Work on getting your stove straightened out and you may find that you like the constant heat without the way up, way down style of heat from a wood stove.

Know nothing about your brand of stove and it would help a lot if ypou could post a picture of what you have and the piping associated with it.
 
I'd bet it needs a good deep cleaning. Yes, please post a pic of the stove so we can figure out what model you have. Then download the manual and I'm sure that someone here will know if there are any "Gotcha" spots that the manual doesn't tell you about.
 
and a sore back...
and bugs and dirt and bark and a mess in the back yard and a worn out truck bed and a rack full of chains and several plugged carburators from the crappy ethanol fuel AND PO'd wife who has to get up every night to feed the stove. Been there, done that for 30 years.
 
Wow, you have some of the best pellets available in the world for a super cheap price. Red Fir pellets are the best I have ever burned. Those $200 dollar a ton pellets are over $300 dollars a ton in other parts of the country if you can even get them. I bet the stove needs a good cleaning like the others have said.
 
  • Like
Reactions: SmokeyTheBear
80% of all pellet stove problems are because of a dirty stove and venting.

99% of all second hand pellet stove problems are because of a dirty stove, maybe the venting, and the end results of torturing the blowers on the stove because of repeated attempts of running it without cleaning.

Clean the stove and venting.

Do a youtube search for Leaf Blower Trick because after the normal thumping, brushing, and vacuuming it will get the last remaining crud out of the works.

Welcome to the forums.
 
  • Like
Reactions: Eatonpcat
Status
Not open for further replies.