Checked all the outlets in the house and all read at roughly 125 volts. Ordering a new esp probe tonight. All DIP switches are off right now. Stove operates normally except for the auger running constantly when turned on. Haven't actually lit a fire yet because all it does it push pellets out of the pot. Would removing the feeder micro-switch fix the auger running constantly? I appreciate any and all help you guys can give me because I'm up a creek without a paddle and winter is coming.
Harman Invincible Insert Mid 90's
- Thread starter Miserabledude
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
We only replaced the board and a new wire harness because it melted. Replaced all wires one by one to ensure proper placement. Did you remove the micro-switch??
There is one wire that went no where because there no place for it when I put in new board. I don't know if that was micro-switch i think it was the feeder switch.
Replaced esp probe and removed micro switch from feeder body. Auger is still running constantly and the feeder light on the board has not come since replacing the board?
- Status
Similar threads
