Okay I'm confused about the jumper setting for auger feed rate. Seems like conflicting information on the forums verses from AES. Also, are the pins numbered left to right? Also, my Baby doesn't even turn on if I have the slider switch on Auto. It has to be on Manual for the power switch to work. (See suggestions below)
From thee forums:
"Make sure the jumper on the control board is on Pins 1 & 2 for wood pellets for auger timing."
"1&2 for wood pellet heat and the slide switch set to the Auto setting."
"The TMC needs to be placed over the 1 & 2 pins for the MagnuM Baby Countryside models (BC-AC & BC-DC, factory default setting for wood pellets) if you are burning wood pellets only and need a little more heat."
From AES: wood pellet fire pot "Appropriate jumper setting: The number 3 & 4 pin location is the factory default setting. 99% of households will work under this setting. The number 1 & 2 pin location is only used on the Baby should the customer need a little higher feed rate because the fuel is not feeding properly and the unit is not getting enough fuel."
http://www.americanenergysystems.com/Stock/LibraryFiles/P-0013TechBWoodPelletFirepot.pdf
Mine is on the two rightmost pins. Thanks!