Harman p43 troubles

joe simmons · Feb 19, 2016

On my second season with it up until yesterday no issues, now the pellet feeder is feeding pellets constantly overflowing the burn pot into the ash pan , it stops for a few seconds and the. Goes again, I even shut it off and the darn thing still fed pellets , anyone have this issue,? Not getting any blinking codes either ! It fired up like normal too

gfreek · Feb 19, 2016

Did you try turning it off, unplugging and plugging it back in ? last cleaning with cleaning ESP (exhaust sensor probe)..?

PJPellet · Feb 19, 2016

I have had my P43 for 5 years. This happened to me for the first time about two months ago. I did as mentioned above; unplugged and then plugging it back in fixed the problem. Sometimes these computer boards get flaky and act strange. Keep us posted. Good Luck.

Peterfield · Feb 19, 2016

Had it happen to me once, did the same thing, unplugged the stove for a few minutes and that seemed to cure it.

bags · Feb 20, 2016

Kinda like re-booting a router or computer. I unplug mine at every thorough cleaning but it is only on its second season also so I do not expect any issues.

TonyVideo · Feb 20, 2016

I put in a UPS that the manual listed for conditioning and never had the issue pop back up for me.

Search

Search

Harman p43 troubles

joe simmons

Member

gfreek

Minister of Fire

PJPellet

Minister of Fire

Peterfield

Minister of Fire

bags

Minister of Fire

TonyVideo

Feeling the Heat

Similar threads