Hi everyone,
We have a PB-105 that we had installed 2 years ago. The first year was tough, we experienced the now common issue with the hump in the burnpot, but once we got that replaced everything was running perfectly for a year and a half. I just went through and cleaned everything out and tried to fire it up to make sure everything was working before the season started but it doesn't do anything.
Here's what happens when I turn it to TEST on the control panel:
Combustion motor light is on but the fan doesn't kick on so there's no airflow
Overheat light comes on
No light or activity from the feeder
I took the little side panel off of the auger and cleaned out all of the pellet dust and when I manually turn it the slide plate is moving and unobstructed. I cleaned out the combustion motor area, boiler chamber, burn pot and fines chamber where the ignitor is, as well as the flue. I did this all last year and had no issues.
What can I test to see where the issue lies? What should be coming on first, what would stop the TEST cycle from initiating?
PS I also noticed a small hump beginning to form in the burnpot.
We have a PB-105 that we had installed 2 years ago. The first year was tough, we experienced the now common issue with the hump in the burnpot, but once we got that replaced everything was running perfectly for a year and a half. I just went through and cleaned everything out and tried to fire it up to make sure everything was working before the season started but it doesn't do anything.
Here's what happens when I turn it to TEST on the control panel:
Combustion motor light is on but the fan doesn't kick on so there's no airflow
Overheat light comes on
No light or activity from the feeder
I took the little side panel off of the auger and cleaned out all of the pellet dust and when I manually turn it the slide plate is moving and unobstructed. I cleaned out the combustion motor area, boiler chamber, burn pot and fines chamber where the ignitor is, as well as the flue. I did this all last year and had no issues.
What can I test to see where the issue lies? What should be coming on first, what would stop the TEST cycle from initiating?
PS I also noticed a small hump beginning to form in the burnpot.