I have a 92 Invincible T and its not keeping the pot full and burning back to the auger. I have tried adjusting the auger and will keep it full if i burn at a heat setting of 4 and up for an hour or so then it creeps back to the auger. I have checked to see if i am getting air from the hopper but opening the lid doesn't change the flame. checked the door seal, motor seals, cleaned the heat exchanger tubes and vacuumed every nook and cranny i could get too in the process, the flame guide is in good condition.I have cleaned the crap out of this thing and its still doing it. is something misaligned? can the burn pot be removed and reset or is i welded in place? is there a gasket there?
Here is a little back history on it. previous owner never cleaned and control board has been replaced, the burn pot was full of charcoal cooked into the pot and all holes at the edge of the burn pot were blocked. chipped out all the crap and cleaned the holes. cleaned out inside the burn pot where the blower pushes the air to the holes. puts out heat like crazy but want proper operation. thanks
Here is a little back history on it. previous owner never cleaned and control board has been replaced, the burn pot was full of charcoal cooked into the pot and all holes at the edge of the burn pot were blocked. chipped out all the crap and cleaned the holes. cleaned out inside the burn pot where the blower pushes the air to the holes. puts out heat like crazy but want proper operation. thanks