recently got a 25pvdc and this very morn i fired it up in the driveway. all appeared to be fine, top auger feeds, bottom one too, blower works etc, etc, which is great news considering the cost (free
)
i took the back plate off, vacuumed it out and took a look around and everything seemed good, more great news. i cleaned out the burn pot, sanded the outside down and gave it a fresh coat of high temp oven paint and it looks basically new.
here are the questions i have as i am ready to install this baby
-when i fired it up the exaust "air" seemed warmer than the blower air that goes into the room, is this normal? (i had nothing hooked up on the back, ie no exaust pipe nor outside air intake)
-what maintenance should i be doing other than the general cleaning of everything i have already done??
-i was lucky enough to ge the
)
i took the back plate off, vacuumed it out and took a look around and everything seemed good, more great news. i cleaned out the burn pot, sanded the outside down and gave it a fresh coat of high temp oven paint and it looks basically new.
here are the questions i have as i am ready to install this baby
-when i fired it up the exaust "air" seemed warmer than the blower air that goes into the room, is this normal? (i had nothing hooked up on the back, ie no exaust pipe nor outside air intake)
-what maintenance should i be doing other than the general cleaning of everything i have already done??
-i was lucky enough to ge the