Accentra Insert Question

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

Tarbot

New Member
Hearth Supporter
Sep 3, 2009
24
Central MA
How does the 4" flex chimney liner get connected to the outlet from the stove rack? Is there an adapter (flex to appliance)?
Can you just insert the flex inside the outlet and put some screws in and seal around the top lip? The install manual is a little vague on this part.

Thanks
 
It has a 4" stub that connects to the top of the docking plate to your flex.. You don't need a pipe to the stove. When you slide the stove in, the two meet at the docking plate and completes the connection. You should have a gasket attached to the stove that seals the stove to the docking plate when the stove is slid in. hths
 
My flex liner kit came with the appliance adapter. But it was a very tight fit into the swivel collar on the frame. I don't think there would be any problem just inserting the flex into the swivel collar if it is a good fit. High temp silicone and screws of course.
 
Status
Not open for further replies.