I'm confused how the Outside air connection is supposed to hook up to my stove? :roll:
Is there a square adapter that I need to get from BK?
Thank you,Hiram
Is there a square adapter that I need to get from BK?
Thank you,Hiram
Wet1 said:Yes, you'd need to buy an adapter from BK. I ran a 4" line to mine, but I haven't hooked it up yet. I don't really want to pay BK for such a simple adapter, so I was going to fab a piece or see if HD/Lowes carries something that might work.
Wet1 said:I just need to make an adapter to go from my 4" to the rectangular input...
learnin to burn said:Thanks North, that's one nice looking stove there....
Hiram - Did you do the break in fire inside or outside? If inside Welcome to the stink yourself out club :-S
You should be able to extend the 3 inch section to what ever length you need then just use the flange at the wall exit. You can pick up a decorative ring of something to dress up the hole in the floor.
north of 60 said:I wouldnt run mine without it. I also made a sorta P-trap to stop the natural convection of cold air dropping right at the bottom near the connector. Make sure you insulate. Enjoy your new stove.
N of 60
Lanning said:Why a OAK for the BK.
Do they make one for the BKPI?