I have been struggling with my Englander 10 CDV stove. Originally threw a E-3 code...I noticed the firebrick had some breakage...ordered new and replaced...stove ran for 6 hours fine...then started throwing both E 3 or E 2 codes...
So...
- pressed all threw buttons at bottom of control panel to reset to factory settings
- checks both intake and exhaust pipes
- cleaned thermal sensor
- check control panel for various
- just ran all the diagnostic with Englander tech
- unplugged thermal sensor - while no fire in stove
- ran S U code
- hooked up thermal sensor with no fire in stove --- ran E 3 code (but no fire in stove)
- then back to E 2 code
Anyone got any ideas
So...
- pressed all threw buttons at bottom of control panel to reset to factory settings
- checks both intake and exhaust pipes
- cleaned thermal sensor
- check control panel for various
- just ran all the diagnostic with Englander tech
- unplugged thermal sensor - while no fire in stove
- ran S U code
- hooked up thermal sensor with no fire in stove --- ran E 3 code (but no fire in stove)
- then back to E 2 code
Anyone got any ideas
