As I was messing around in the rim joist area trying to squeeze in some foam board in the corner where the electric panel is (btw, there's no way that stuff is fitting in there), I noticed that the big conduit bringing the main power into the panel was wet, and dripping.
It turns out there doesn't appear to be any duct seal in the conduit.
The cold air was pouring in.
My plan is to put some duct seal in the end of the conduit in the panel.
Maybe some spray foam, or some other insulation on the outside of the conduit run from the rim joist to the panel.
It turns out there doesn't appear to be any duct seal in the conduit.
The cold air was pouring in.
My plan is to put some duct seal in the end of the conduit in the panel.
Maybe some spray foam, or some other insulation on the outside of the conduit run from the rim joist to the panel.