1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Hearthstone Soapstone and Cast-Iron stoves( Wood, Gas or Pellet Stoves and Inserts)

Install question?

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by IIFAST4U, Mar 24, 2008.

Thread Status:
Not open for further replies.
  1. IIFAST4U

    IIFAST4U Member

    Joined:
    Feb 27, 2008
    Messages:
    56
    Loc:
    Western, RI
    I am installing my stove this week. I am handy enough to handle the install plus I already checked with building inspector and my insurance company. My question is I am installing the stove in a corner with two outside walls, Once I set the stove where I want it to clearance codes and line up my vent pipe, what do I do if I end up at a wall stud where i need to cut? move the whole stove? or cut the stud and support it? any other suggestions? instead of a 45deg. should I use a flex pipe?

    Thanks
    Shawn

    Helpful Sponsor Ads!





  2. Southbridge06GT

    Southbridge06GT New Member

    Joined:
    Feb 23, 2008
    Messages:
    31
    Loc:
    Central Mass
    cut the stud and support it with a header and jack studs
  3. IIFAST4U

    IIFAST4U Member

    Joined:
    Feb 27, 2008
    Messages:
    56
    Loc:
    Western, RI
    Thats what I was thinking but I was hoping to avoid it. LOL, less cutting the better plus my walls do not have todays 2 X 4's they still have the bark on two sides. the house was built in 1885. I just have to hope when I get it all in place that I clear the 2 X 4 studs.

    Thanks
    Shawn
Thread Status:
Not open for further replies.

Share This Page