PelletVent Pro Wall Thimble Air Intake Kit

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by no1psycho, Aug 7, 2008.

Thread Status:
Not open for further replies.
  1. no1psycho

    no1psycho
    Expand Collapse
    New Member

    Joined:
    Jun 11, 2008
    Messages:
    31
    Likes Received:
    0
    Loc:
    Eastern Maine
    I've gotten a lot of help from everyone here so I figured I'd throw this one on you too. I'm planning on using the PelletVent Pro Wall Thimble Air Intake Kit part #4PVP-WTI. Looking at the diagram in the catalog it looks to only have 4" in between the end plates. The other thimble kits are adjustable from 4"-8". Is this one adjustable also and they just didn't put it in the diagram or is it fixed like it shows in the picture? It seems to me that most exterior walls would need more than 4".

    Thanks in advance for any help.

    Greg
     

    Helpful Sponsor Ads!





  2. jtp10181

    jtp10181
    Expand Collapse
    Minister of Fire

    Joined:
    Feb 26, 2007
    Messages:
    3,729
    Likes Received:
    3
    Loc:
    Madison, WI
    We have used the 3" version of that before and no one had any problems with it. It should be adjustable like the others.
     
    Collapse Signature Expand Signature
  3. kinsmanstoves

    kinsmanstoves
    Expand Collapse
    Minister of Fire

    Joined:
    Aug 29, 2007
    Messages:
    3,471
    Likes Received:
    499
    Loc:
    Ravenna, Ohio 44266
    As far as I know it it the same sizing as the standard 3PVP.

    Eric
     
    Collapse Signature Expand Signature
Thread Status:
Not open for further replies.

Share This Page