Stupid Question

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

biggins08

New Member
Hearth Supporter
Sep 20, 2006
227
Springfield MA
Will a saw running a .58 bar in cahin in 3/8 run a .50 bar and cahin in thee same pitch?
 
If you mean changing bar and chain, both, to .058 or .050, leaving only the clutch sprocket alone, then yes. 3/8 is 3/8.

If you mean mixing the bar or chains, no. .050 chain needs .050 bar and vice versa.

But if the bar is worn, I'd change the sprocket also. Only $5. Unless you have a spur sprocket intregral with the drum. If there is any wear groove, rather than replace the drum and spur, it might be a good time to change to rim drive drum and rim.

If the spur does not have grooves in it, change the bar and chain and go to work.
 
Status
Not open for further replies.