I have a thermostat to control the circulator in my workshop. I want to share this thermostat with a Taco SR503 switching relay on zone one to control a pump in the boiler room so both pumps come on at the same time. I don’t believe I can connect both thermostat wires to the single thermostat because I am worried about the two different transformers conflicting. Am I correct?
Is there a switch I could connect to the 120v output or 24 volt on the Honeywell relay (like a normally open) that would energize when the thermostat activates the Honeywell Relay closing a switch to activate the Taco?
Am I complicating this?
Is there a switch I could connect to the 120v output or 24 volt on the Honeywell relay (like a normally open) that would energize when the thermostat activates the Honeywell Relay closing a switch to activate the Taco?
Am I complicating this?