Hi All.
Power went out for about 5 hours last night -- had a real good burn going at the time of the outage. Once the power went out, I turned the stove off (didn't want it relighting on auto-pilot when the power came back on). There was a lot of smoke in the stove and a smoke smell in the house.
When the power was back on today, I fired up the stove -- room temp mode, 70 degrees. Nothing but some clinking as the auger fed the burn pot to the point that the pellets spilled into the ash pan. Cleaned out the pan, emptied and scraped the burn pot, ran it in test mode, all lights lit up, all motors seemed to be working. I turned the stove back to 70 degrees, and again, nothing. The useless red light beside the word "Ignitor" tells me I'm getting a current, at least.
The pot is warmish, there's signs of some embers, but I can't get a fire.
Help?
Power went out for about 5 hours last night -- had a real good burn going at the time of the outage. Once the power went out, I turned the stove off (didn't want it relighting on auto-pilot when the power came back on). There was a lot of smoke in the stove and a smoke smell in the house.
When the power was back on today, I fired up the stove -- room temp mode, 70 degrees. Nothing but some clinking as the auger fed the burn pot to the point that the pellets spilled into the ash pan. Cleaned out the pan, emptied and scraped the burn pot, ran it in test mode, all lights lit up, all motors seemed to be working. I turned the stove back to 70 degrees, and again, nothing. The useless red light beside the word "Ignitor" tells me I'm getting a current, at least.
The pot is warmish, there's signs of some embers, but I can't get a fire.
Help?