Hello All,
I have a friend that has a new Enviro Milan and we can not get it to burn with a strong flame after increasing the feed rate trim and adjusting the combustion blower trim. We have jumped around the vacum switch, and also jumped around the 200 degree Manual Reset. The problem persists.
The stove will ignite and burn half way ok for a few minutes and then it will just not feed enough pellets in the burn pot to retain a strong flame. This is the same on Manual High and also Automatic connected to a thermostat.
Any Ideas Amigos??
Thanks,
AR
I have a friend that has a new Enviro Milan and we can not get it to burn with a strong flame after increasing the feed rate trim and adjusting the combustion blower trim. We have jumped around the vacum switch, and also jumped around the 200 degree Manual Reset. The problem persists.
The stove will ignite and burn half way ok for a few minutes and then it will just not feed enough pellets in the burn pot to retain a strong flame. This is the same on Manual High and also Automatic connected to a thermostat.
Any Ideas Amigos??
Thanks,
AR