1997 P38+ Dead when powered

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.
S

Sailor13

New Member
Nov 14, 2014
1
Revelstoke, BC
Hello there forum members, my wife and I are new to pellet stoves and recently came to owning a used p38+ when based on the inspection date was built in 1997. When we plugged the stove in for the first time to test it before installing nothing happened, no fan, no auger, no blower. Any thoughts on where we could start to eliminate possible causes?

Any advice is greatly appreciated as we are shooting in the dark. Thank you,
 
Welcome to Hearth.com. If the outlet has power to it, the next thing to check is the fuse.
I believe it's ocated on the back of the circuit board, but on a model of that vintage, I could be wrong...
 
Yup, check to see if there is a fuse of some sort..
 
Status
Not open for further replies.

Similar threads

M
1997 Harman pp38+ auger issue
Replies
1
Views
682
The Pellet Mill - Pellet and Multifuel Stoves
johneh
johneh
R
Pellet stove fills room with smoke
Replies
15
Views
736
The Pellet Mill - Pellet and Multifuel Stoves
RM Donaghy
R
S
Harman P38+ with thermostat
Replies
0
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
skawood
S
D
HOW DO YOU INSTALL AN AUGER MOTOR ON A WHITFIELD QUEST PELLET STOVE?
Replies
18
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
DarbyDog
D
Y
Original Mt Vernon stove Control box issue
Replies
0
Views
613
The Pellet Mill - Pellet and Multifuel Stoves
YANKEEBOB
Y
Top Bottom