My vent comes off the furnace with a 45 degree adapter to a clean out "T" with the "T" being horizontal with the end cap facing me so it can be removed. Then off the "T" a 45 degree 3 foot up slope. Then a 45 degree to a straight horizontal between the floor joists to the outside "T" where it goes vertical 7 feet. Will the lint eater extension rods make it through the two 45's that are after the inside clean out "T" OK? I've read that the rods are pretty flexible and if you need some force to get through a tight spot, the rods flex too much and don't push through. The total length of the inside vent is just about 12 feet in length to where it meets the outside "T". Anyone have any experience with this?
Thanks.
Thanks.