Accentra 52i 2 Blink Error

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here

ChrisA

New Member
Jan 17, 2019
1
Maryland
This is very frustrating. I did have a bad igniter which I replaced. Then got a 6 error code.... replaced the red esp probe.... then the circuit board. On startup everything is fine but the Distribution doesnt run. Now an error 2. So the combustion runs constantly while blinking status 2. When I run a test, everything runs fine even the Distribution blower....

Also the replacement board has two different dipswitch settings but I dont see where the revisions are noted.... A,B,C setting and D & Up.
 
I'd start with a deep cleaning including the entire vent.