Breckwell P24I Igniter

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

phatdawg

New Member
Dec 13, 2014
4
Eureka, CA
My igniter quit working. For now, I got it lit an am leaving the stove on low until I get it fixed. Should I just order a new one and replace or should I pull it out and verify power to it first. Even if it is something else might be good to have on hand. I was looking to get from

(broken link removed to http://woodheatstoves.com/breckwell-pellet-stove-super-ignitor-p-18593.html?cPath=499_502)

Thanks for any advise. Also is there a special tool to loosen? BTW, I cleaned the pot and the igniter is not getting warm at all. The stove is a 2008 model.

-Mike in Eureka CA
 
Sorry no one got back to you ...

You can try searching the forum for other troubleshooting tips if they are not found in your manual. Remember to unplug your stove before ...

Old thread: https://www.hearth.com/talk/threads/breckwell-p24i-slow-to-light.55881/#post-756881
Ignitor should ohms test at 45 -50; can cord test with external electrical cord to determine if it is just the ignitor

Good luck & keep us posted...
 
Status
Not open for further replies.