Harman Accentra 2 Free Standing (FS) - Blowing fuses / auger not moving

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Whitenuckler said:
One other thing to try is to make sure the switch works and the contacts close. If you don't have a meter, you could use your test cord with a light bulb as a tester. You can remove the switch and apply a vacuum by "sucking" gently on a hose attached to it.
Click to expand...
Lets just use a DMM. The test cord will cause a 120vac dead short.
 
  • Like
Reactions: johneh
Ssyko said:
Lets just use a DMM. The test cord will cause a 120vac dead short.
Click to expand...
Yes, make sure not to use just the test cord without the light bulb as a load or it will be a dead short, and the fuse will blow.
 

Attachments

  • [Hearth.com] Harman Accentra 2 Free Standing (FS) - Blowing fuses / auger not moving
    Lamp Tester.webp
    141.5 KB · Views: 4
You must log in or register to reply here.

Similar threads

P
Whitfield Advantage II T auger motor issues
Replies
23
Views
621
The Pellet Mill - Pellet and Multifuel Stoves
Ssyko
Ssyko
A
Englander 25-pdvc
Replies
8
Views
324
The Pellet Mill - Pellet and Multifuel Stoves
ericofmaine
ericofmaine
NHMAN1
Harman P38 Control Board Install questions
Replies
1
Views
523
The Pellet Mill - Pellet and Multifuel Stoves
NHMAN1
NHMAN1
MrJitters
Help with a chirping noise!!
Replies
13
Views
563
The Pellet Mill - Pellet and Multifuel Stoves
Whitenuckler
Whitenuckler
NHMAN1
Upgrade Harman P38 control board wiring
Replies
0
Views
379
The Pellet Mill - Pellet and Multifuel Stoves
NHMAN1
NHMAN1
Top Bottom