Trying to troubleshoot a low flame height even on a feed rate of 6. My unit is underpowered so I have the temp all the way up but not a great flame height. Stove is newer and just cleaned. At times, it seems the flame is ok and gets up there but mostly only about 4 inches or so. Can I run it in room temp mode without the esp since I never get to the required temp anyway since I'm underpowered? Even on 6, my pellets are a good 2.5 inches away from spilling off the front. Shouldn't I be getting a good 6 inch flame consistently with pellets getting close to the front of burn pot and falling off? I'm seeing a lot of fluctuation in flame height which tells me the esp is hard at work and not sure why when I have the temp all the way up on 6 feed. Can I try using it without the probe?
Last edited: