Hello All, I have a Harmen Accentra insert. the combustion Fan and the distribution fan remain running constantly I have replaced the control board(thinking it was bad potentiometers) the ESP probe And the room sensor. When I turned the unit back on the comb and dist fans would still run constantly but now I was getting 3 blinks on my status light even though I replaced the ESP probe. Needless to say I am beyond frustrated. On the board I set the dipswitches to the suggested 00100100 for the accentra insert revision D and up. Any further suggestions on what can be going on? The part number of the new board I picked up is a 1-00-05886F.