As seen in the photo the wooden support beam is 15 1/2 inches above the top of the insert .The area in the center gets very hot when the blower isn't running should I raise it to a higher level to be on the safe side . Thanks
interior wall combustables
- Thread starter alphahugh
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
sorry, no photo. But yeah, check out pyrolization of wood. It basically says that the more heat wood is exposed to over time, the lower the flash point gets. Either heat shield it or raise it, if it gets "very hot". Warm is probably fine. Hot is not.
JOshua
JOshua
- Status
Similar threads
