I have a king kp60 so I went to get it ready for this season and after I've already cleaned, on startup it will barely move the auger and the draft fan will be spinning but it stops feeding an doesn't ignite. I've bypassed all the switches to come to a conclusion that im lost. I've ran it in test mode an everything works fine.
King KP60 Draft Light Blink
- Thread starter Tw360797
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
ericofmaine
Feeling the Heat
Not familiar with your stove at all but a quick look through the manual seems to indicate a vacuum switch or pressure problem. As others will no doubt ask, have you given the stove a good deep clean?
Eric
Eric
Whitenuckler
Minister of Fire
Did you jumper the pressure switch? And if so, what was the result?
Yes I jumped the pressure switch and it done the same thing. Made sure hose was clean as well an switch seems to works when you slightly blow into it
Whitenuckler
Minister of Fire
Thats what im beginning to think now unfortunately, any way to test control board?
Whitenuckler
Minister of Fire
Yes, the board can be tested by the board supplier. The best thing would be to get a new card. There's not much you can do on your own.
You can try removing the card and cleaning it, and also inspect it.
Whitenuckler
Minister of Fire
Also, I would install whole house surge protection in your panel, and also use a surge outlet for the stove.
Similar threads
