Looking for advise on my LOPI Yankee pellet stove. Had a hot igniter issue so I was working on the control board and subsequently fried it. Replaced the control board now it's indicating an electrical fault. The stove turns on, fan kicks on but the auger does not appear to be turning. Any help would be greatly appreciated.
LOPI Yankee
- Thread starter howegd
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Whitenuckler
Minister of Fire
I didn't see a wiring diagram in the above....
You could have a vacuum leak. If you jumper the vacuum switch that will tell you. You must jumper the wires when the power is off, and isolate the jumper from ground.
Similar threads
