I bought this stove around the first of the year and now got around to hooking it up. It took 3 times of the initial start up instructions to light but it did. It wasn’t feeding very hard. And started going out. But no codes or blinking lights came on. I re started it. Still no feed at all. I took side panel off of it to find the auger unplugged. So re started it again. The motor worked but was spinning counter clockwise and auger wasn’t turning. It was wrapping the wires around it. I grabbed it and held it still and the auger began to turn. The stove worked great. Now I’m trying to figure out how to solve this issue. Does anyone have insight on this. I looked everywhere and can’t find where it says there’s a bracket for this motor. Replacement instructions say pull the pin unplug and take out. Thanks in advance