Oh hi,
I too have a PE Summit and wondered the same thing. This thread has been very helpful. I have a 2300 sqft house, single story. I have added through-wall fans and a antic mounted fan with ducts to distribute the air...hopefully this will work. (House has a boiler- radiant heating system) I load up, full air till the wood chars. The flames are dancing so so much that it isn't obvious to see the secondary burn. When I turn down the air I see the secondary burn. I point an IR gun point just above the door and it reads any where from 550 to 700. I then settles in at 500s. I am using oak in the Santa Cruz mtns. Actually not cold enough here yet, where cold is only the 30s and 40s. (but hey, I did my time, farm house out side of Winnipeg Manitoba
-Glen
I too have a PE Summit and wondered the same thing. This thread has been very helpful. I have a 2300 sqft house, single story. I have added through-wall fans and a antic mounted fan with ducts to distribute the air...hopefully this will work. (House has a boiler- radiant heating system) I load up, full air till the wood chars. The flames are dancing so so much that it isn't obvious to see the secondary burn. When I turn down the air I see the secondary burn. I point an IR gun point just above the door and it reads any where from 550 to 700. I then settles in at 500s. I am using oak in the Santa Cruz mtns. Actually not cold enough here yet, where cold is only the 30s and 40s. (but hey, I did my time, farm house out side of Winnipeg Manitoba
-Glen