My 2000 Quadra Fire Castile, has developed a problem the convection (lower) blower. The stove starts and runs fine. The fan comes on after a few minutes like it's supposed too. If I select high fan speed, the fan will start to increase and then the unit goes into a resetting loop. It sounds as if the fan stops for a split second and then restarts only to quickly repeat. There is a relay on the board that is clicking at each reset. If I switch back to low I have to lower the thermostat for a second, stopping the call for heat and then turn it up and the stove will work fine again.
Quadra Fire castile Convection motor cycles on high
- Thread starter ATCKIP
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Similar threads
