My QuadraFire Mt Vernon exhaust fan will not shut off ever, unless you unplug the stove. I don't think it is the fan itself because that was replaced because of a bad bearing. Even before I replaced the whole fan I was having this issue. Any suggestions?
QuadraFire Mt Vernon Help Please!!
- Thread starter psuwiggs
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
It is not under warranty. When you say motherboard issue are you talking about the control box?
Yea, unfortunately that's what I am talking about. I have attached a Quadrafire troubleshooting manual for you to check out, it may help diagnose it.
Stoveguy not sure what you mean. It's not the AE if that's what you're asking.
I put a new control box in and it did not fix the problem.....
I put a new control box in and it did not fix the problem.....
how long do you let the blower run for it will run for 15-20 minutes every time you lose power to the stove if the what setting did you put the control board on i think it comes on test mode from the factory you need to adjust it,
Hmmm.... didn't know it did that when you lose power. I'm letting it go through a "cycle" as I type this. I set the control board to the "mt Vernon" setting. Turning the knob to 1 with a screw driver.
! Yes
- Status
Similar threads
