secondary stove over-night burn results (not cat stoves)

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

brian89gp

Minister of Fire
Hearth Supporter
Mar 15, 2008
505
Kansas City
Just curious of the results people are getting from an overnight burn with a secondary burn stove. I'll start.

Hours: 8
Blower: yes, on high
Cruise temp: 650
Morning temp: 150
State of fire in morning: 2" thick coal bed
Wood: soft maple, black walnut, locust, and osage orange
Stove: Buck 85 insert


The wood type doesn't seem to matter much for the state of the coal bed in the morning. The locust and osage orange I burn with more air so it cruises at 650 for longer but still seems to burn down to the same state of a coal bed in the morning.
 
The secondary burn stove I just removed from my house:

Hours: 6-7
Blower: NA
Cruise Temp: 600
Morning Temp: 100
State of Fire in Morning: Very few coals, had to start fire from scratch most mornings.
Wood: Red Oak
Stove: Heatilator Arrow 1490
 
Hours: 6-7
Blower: No
Cruise Temp: 500-600 (not sure as I'm asleep)
Morning Temp: anywhere from 150-275
State of Fire: plenty of coals- easy to restart wit hfull splits
Wood: I was told mostly oak when I bought it. It's definitely dry but maybe not all oak.
Stove: 30 NC
 
10-12hrs.on 8-10 medium splits
Normally top temp 450 at the 8hr mark but have seen 500
Start out at 750 sometimes hotter, sometimes cooler.
 
Hours: 6-8 hours
Cruise temp: 450-600
Morning temp: Never pay attention to the stove temp . . . only that the oil boiler set to come on at 60 degrees F has not kicked on
State of fire in morning: coals
Wood: red maple, elm, beech, white birch, yellow birch, ash
Stove: Jotul Oslo
 
Hours : 8
Blower : Low
Cruise Temp : 600-750
Morning Temp : 200-300
Morning State : 1-2" bed of coals (splits refire in < 1 minute)
Wood : Oak and Maple mix
Stove : 30 NC
 
Hours : 7 without too much fiddling, best ever (stars and planets aligned) was @ 9 hours
Blower : none
Cruise Temp : 500 flue temp (no stove top thermo)
Morning Temp : under 200 (under 200 is mostly a guess on this temp probe) but I get enough heat for a pine / cedar / small split restart
Morning State : probably just over 1" bed of coals
Wood : Maple & Yellow Birch with occasional bit of Oak (from milled ends) mixed in
Stove : Osburn 2200​
 
Status
Not open for further replies.