.......when I set the feed rate below #2. It seems the flame is just too low and does not put out enough heat . I would think the exhaust sensor probe (ESP) is sensing the lower heat output and turning the blower off..
Can someone confirm this and is this normal?
I was under the impression the fan would operate at the #1 setting or at least at #1.5.
I`m an electrician and getting it to run at any temperature wouldn`t be difficult but maybe it will work fine as it is.
John
Whoops! Sorry . I`m new here and will ask this question in the pellet forum.
Can someone confirm this and is this normal?
I was under the impression the fan would operate at the #1 setting or at least at #1.5.
I`m an electrician and getting it to run at any temperature wouldn`t be difficult but maybe it will work fine as it is.
John
Whoops! Sorry . I`m new here and will ask this question in the pellet forum.
