Traditions T300P, lights come on but that's it.

[Amhirean]

My auger motor had went bad. Upon start up though blower and exhaust would run and ignitor would work. After replacing it when I turn it on and place a call for heat nothing happens. No fan motors no ignitor. Tried testing the old motor to see if it was just the new auger motor. The results were the same, lights for power are on and a call for heat but still none of the fan motors are coming on. What could this be?
Mode is a traditions t300p as stated in the title

 

[Ssyko]

did you check the connections on the control board for the high limit switch and the connections on the high limit switch itself? might have knocked one off or loose when changing the auger