Have had this unit installed for 6 years. It never has performed well and will not accept even a half load of split oak without running out of control. So will be looking for an alternative.
But, just installed a new combustor and cleaned stove and stack (@30ft). I removed the cover from the secondary air entry. When the stove is cold, the air flap is in closed position. When at operating temperature, the link moves in a direction to (further) close the flap as I believe it should be doing. So, the flap never moves, remaining in it's closed (held slightly open by a dimple on the valve) position. I assume an adjustment is needed but unable to find info. Anyone??.
But, just installed a new combustor and cleaned stove and stack (@30ft). I removed the cover from the secondary air entry. When the stove is cold, the air flap is in closed position. When at operating temperature, the link moves in a direction to (further) close the flap as I believe it should be doing. So, the flap never moves, remaining in it's closed (held slightly open by a dimple on the valve) position. I assume an adjustment is needed but unable to find info. Anyone??.