Help!! We have a Whitfield Advantage stove that has run perfect for 10 years. Now we cannot get it to work. We cleaned everthing-seals, vent, chimney, etc. We tried to jump low limit switch to see if this was the casue of the auger not moving, and replaced the pressure switch. There was power , the motor is fine auger is not jammed, etc.. Jumped the pressure switch, the auger moves. If the pressure switch, a new one was hooked up, the auger still didn't move. Now there is smoke bellowing out from the pipes, with a roaring flame in the pot once the pellets feed. Is this because the pressure switch is jumped. Again , no blockage in the pipes. At a loss for how to repair. No one can come out for 30-60 days!! Any suggestions. Thanks Martha
Whitfield dilemma
- Thread starter marth
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Martha,
You may have already seen this site but here it is anyway: http://www.hearthtools.com/parts/lowlimit.htm
This info has helped my fix several Whitfield stoves.
Goo luck
You may have already seen this site but here it is anyway: http://www.hearthtools.com/parts/lowlimit.htm
This info has helped my fix several Whitfield stoves.
Goo luck
- Status
