Newbie here. Just installed a new Harman PF-100 pellet furnace and I'm loving it. I am concerned about the flame however -- I recently helped my father-in-law install his new PF-100 and my flame acts considerably different from his. His flame angles about 45 degrees to the left and hits directly on the heat exchanger, and looks a lot like the flame videos I've seen on this site. Mine, however, goes straight up from the burn pot. This doesn't seem right to me. Everything seems to be connected correctly, and the whole system works. The flame just doesn't seem to be quite right. I've attached a video.
Is there anything obvious that could cause this? It seems like maybe there should be air coming through the hopper area somewhere to force the flame over, but I can't tell. Thoughts? Thanks!
Is there anything obvious that could cause this? It seems like maybe there should be air coming through the hopper area somewhere to force the flame over, but I can't tell. Thoughts? Thanks!