4 blink status code for Harmon Accentra Insert

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.
I had just posted in your other thread related to your cleaning the stove and switching modes. If all you did was clean your stove, and you have not touched your temp sensor probe, try uplugging the stove for a minute or two and then plug it back in. This will reset your control board. Then see if you get the same error.
 
Status
Not open for further replies.