Good afternoon, I am installing a thermostat (Lux TX1500U) to my 10-CPM Pellet stove and the install seemed pretty straight forward. I put one wire to the G terminal and another wire to the W1 terminal, and then put both wires to the thermostat terminals on the Stove's control panel.
The thermostat seems to have no impact on the stove whatsoever. It will call for heat, but the stove does not answer, and when it calls for the heat to shut off, it also has no impact. The Stove seems to be behaving the same... hit the on button and it fires up.
Any suggestions other than rechecking the wires? I have the stove going to warm the house up now, but will recheck the terminal wires once I can shut the stove off again.
I assume I should use the 1 Stage or 2-Stage Heating Only wire configuration for the stove? Also, anyone know what the C & P stands for when you press both down arrows on start-up? I had read from imacman that both down arrows toggles between on/off & low/high mode if you have a control board that supports it.
Thank you!
The thermostat seems to have no impact on the stove whatsoever. It will call for heat, but the stove does not answer, and when it calls for the heat to shut off, it also has no impact. The Stove seems to be behaving the same... hit the on button and it fires up.
Any suggestions other than rechecking the wires? I have the stove going to warm the house up now, but will recheck the terminal wires once I can shut the stove off again.
I assume I should use the 1 Stage or 2-Stage Heating Only wire configuration for the stove? Also, anyone know what the C & P stands for when you press both down arrows on start-up? I had read from imacman that both down arrows toggles between on/off & low/high mode if you have a control board that supports it.
Thank you!