1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Hearthstone Soapstone and Cast-Iron stoves( Wood, Gas or Pellet Stoves and Inserts)
    Caluwe - Passion for Fire and Water ( Pellet and Wood Hydronic and Space Heating)
Thread Status:
Not open for further replies.
  1. New Harman

    New Harman New Member

    Joined:
    Nov 12, 2007
    Messages:
    4
    Loc:
    albany Ny
    I have a harman p68 that normally works fine until tonight. the stove was down for a few hours as it was warm here in albany today, but it just cme on a little while ago. I noticed that the flame was much larger than usual. Upon looking at the burn pot i noticed it was over full of pellets. I keep my feed at 3. now it has been 10 minutes since i shut the stove down, and every minute or so I can here the feed motor running pellets into the burn pot. Wouldn't the stove stop feeding once i have shut it off?? Please Help!!

    Helpful Sponsor Ads!





  2. GVA

    GVA Minister of Fire

    Joined:
    Sep 4, 2006
    Messages:
    2,140
    Loc:
    Waxhaw, NC... Formerly North shore Mass
    No it won't.. it will feed pellets every so often to gradually bring the stove down to a lower temperature once ESP reaches a certain temp then it will stop feeding and burn out..
    As far as the burnpot being full of pellets and having alot of flames it happens at the initial startup sometimes...... All seems normal....
  3. New Harman

    New Harman New Member

    Joined:
    Nov 12, 2007
    Messages:
    4
    Loc:
    albany Ny
    thanks pyro! Stove seems to be working fine this morning. I think the problem with the buil up is that i forgot to scrape out the burn pot yesterday. I seem to get alot of black "ash" buildup at the top of the burn pot.
Thread Status:
Not open for further replies.

Share This Page